Inner Banner
Article archive
  • Article archive

Tips That Hurt The Turbine

7/4/2017

Hit the head to the turbine. Pressing the button to remove the milling before the full stop Application of old and non-standard cutters and long-length bursaries Excessive lateral pressure on the turbine during cutting

A few points about low speed handpieces

7/4/2017

Angel MME is a type of pembilk bearing. Do not use it at all if you hit the headband. Before you begin, make sure Enogel is fully connected to the airmotor. The three Angelbde system should always be clean. Low Speed